Sentera PHX™ - Airspeed Calibration
Step 1: Click the Gear icon within the Fly PHX software.
Step 2: Click Sensors under Vehicle Setup.
Step 3: Click Airspeed under Sensor Setup.
Step 4: Click OK on the right side of the screen to start the calibration.
Step 5: Follow the on screen instructions to complete the airspeed calibration.
Note: The on-screen directions will eventually instruct the you to blow across the pitot tube to create pressure.
DO NOT blow into the pitot tube.
Instead, press the pad of your finger against the end of the tube to create pressure, as shown in the following video.
Watch this video on how to block and create pressure while preforming the airspeed calibration test of the pitot tube.
Sentera PHX™ - Fly PHX Software
Fly PHX - Flight Control Application Download the latest version of Sentera's Fly PHX software for the Sentera PHX™ fixed-wing drone. Download Version 1.9.1 Windows Download iOS Download Release Notes: Version 1.9.1 Adds Remote ID Support Updated ...
Sentera PHX™ - Compass Calibration
Watch this video for how to do Compass Calibration after starting the calibration procedure inside the Sentera Ground Control software. After starting the Compass Calibration in Sentera Ground Control, follow the onscreen instructions and listen to ...
Sentera PHX - Airspeed Calibration (New Design)
Learn how to calibrate the airspeed sensor on your PHX. Download the latest Sentera PHX Operation Manual Sentera PHX Firmware Update
Sentera Fly PHX - Videos To Get You Started
Watch the following videos in order to understand using PHX: 1. System Overview A brief overview and introduction to the PHX system. 2. Basic Mission Planning Learn how to navigate the Fly PHX mission planning wizard, plan a mission, and save the ...
Sentera PHX™ - Protective Film Installation Video
The video explains how to install transparent film to your PHX to protect it. To purchase the protective film: https://sentera.shop/products/phx-protective-film-kit Download the latest Sentera PHX Operation Manual Sentera PHX Firmware Update